0912101中文資料圖爾克數據手冊PDF規格書

Sensors according to EN 60947-5-6 (NAMUR)

or potential-free contacts can be connected to the IMX12-DI01-2S-2PP-PR/24VDC/

CC isolating switching amplifier. The device

is equipped with two channels, but can also

be used as a splitter. The device is equipped

with intrinsically safe input circuits and can

be installed in zone 2. The output circuit is

equipped with 2 push/pull outputs with a high

cut-off frequency (15 kHz). The device can be

powered from a power bridge that also transmits a collective fault signal. The device complies with the requirements of NE21.

The devices feature DIP switches on the

front. This allows to select between the output

mode, the input circuit monitoring, as well as

toggle between signal duplication and 1-channel operation. When using mechanical contacts, either line monitoring must be switched

off or the contact must be wired with resistors

(see wiring diagram).

The green LED indicates operational readiness. An error in the input circuit causes the

red LED to flash according to NE44. The output level then drops to below 1 V and the

common alarm output switches to conductive.

The device can be used in safety circuits up to

SIL2 (high and low demand according to IEC

61508).

The device is equipped with removable spring

type terminals.

■ Two transistor outputs (push-pull)

■ Switchable: 2-channel or signal doubling

■ Output mode adjustable (NO/NC mode)

■ Input circuits monitored for wire-break/

short-circuit (ON/OFF switchable)

■ Complete galvanic isolation

■ Input reverse-polarity protected

■ Removable spring type terminals

■ Power bridge (connector incl. in delivery)

■ ATEX, IECEx, NEPSI, cUL, cFM INMETRO, Kosha, TR CU EAC

■ Installation in zone 2

■ SIL 2