7580051中文資料圖爾克數據手冊PDF規格書

Sensors according to EN 60947-5-6 (NAMUR)

or potential-free contacts can be connected

to the IM12-DI03-1S-1NAM1R-PR/24VDC/

CC NAMUR repeater. This can be installed

in zone 2. The output circuit is also equipped

with a relay output. The device can be powered from a power bridge that also transmits

a collective fault signal. The device complies

with the requirements of NE21.

The devices feature DIP switches on the

front. This allows to select between the output

mode, the input circuit monitoring, as well as

toggle between signal duplication and 1-channel operation. When using mechanical contacts, either line monitoring must be switched

off or the contact must be wired with resistors

(see wiring diagram).

The green LED indicates operational readiness. An error in the input circuit causes the

red LED to flash according to NE44. A LOW

level is then output at both outputs and the

common alarm output switches to conductive.

The device can be used in safety circuits up to

SIL2 (high and low demand according to IEC

61508).

The device is equipped with removable spring

type terminals.

■ Relay output (changeover contact)

■ NAMUR repeater

■ Output mode adjustable (open-circuit/closed current mode)

■ Input circuits monitored for wire break/

short circuit (ON/OFF switchable)

■ Complete galvanic isolation

■ Input reverse-polarity protected

■ Removable spring type terminals

■ Power bridge (connector incl. in delivery)

■ ATEX use in Zone 2, cUL

■ SIL 2