CS2001YDWFR20集成電路（IC）的線性穩壓器控制器規格書PDF中文資料

CS2001YDWFR20屬于集成電路（IC）的線性穩壓器控制器。由安森美半導體公司制造生產的CS2001YDWFR20穩壓器 - 線性 + 開關此產品族中的產品用于構建執行 DC-DC 轉換或電壓調節功能的電路，采用的是開關模式和線性穩壓器功能的組合。雖然具體的拓撲各不相同，但此類產品的主要目的是將開關模式技術的效率優勢與線性穩壓技術的低噪聲特性結合在一起。

The CS2001 is a smart power supply ASIC utilized in automotive airbag systems. It contains a current–mode switching regulator with a 1.2 A on–chip switch and a 5.0 V, 100 mA linear regulator. The linear output capacitor must be 3.3 μF or greater with an ESR in the range of 100 m? to 1.0 ?. If the ESR of the cap is less than 100 m?, a series resistor must be used. The switcher can be configured in either a boost or flyback topology. The boost topology produces energy reserve voltage VER which is externally adjustable (25 V maximum) through the resistor divider connected to the VFB pin. In the event of fault conditions that produce VFB either open or shorted, the switcher is shut down.

Under normal operating conditions (VBAT > 8.0 V), the current loading on the linear regulator is directed through VBAT. A low battery or loss of battery condition switches the supply for the linear regulator from VBAT to VER and shuts down the switcher using the ASIC’s internal “smartswitch.” This switchover feature minimizes the power dissipation in both the linear and switcher output devices and saves the cost of using a larger inductor.

The NERD (No Energy Reserve Detected) pin is a dual function output. If VOUT is not in regulation, it provides a Power On Reset function whose time interval is externally adjustable with the capacitor. This interval can be seen on the RESETB pin, which allows for clean power–up and power–down of the microprocessor. Once VOUT is in regulation, the logic level of the NERD output (usually low) indicates to the microprocessor whether or not the VER pin is connected.

A switched–capacitor voltage tripler accepts input voltage VER and produces output voltage VCHG (typically VER + 8.0 V). This voltage is used in the system to drive high–side FETs.

This part is capable of withstanding a 50 V peak transient voltage. The linear regulator will not shut down during this event.

Features

? Linear Regulator 5.0 V ±2 @ 100 mA

? Switching Regulator 1.2 A Peak Internal Switch

? Voltage Tripler

? Smart Functions

– Smartswitch

– RESET

– Energy Reserve Status

? Protection

– Overtemperature

– Current Limit

– 50 V Peak Transient Capability

? Internally Fused Leads in SO–20L Package