LTC3888集成電路（IC）的PMIC-穩壓器-DCDC開關式控制器規格書PDF中文資料

LTC3888屬于集成電路（IC）的PMIC-穩壓器-DCDC開關式控制器。由亞德諾半導體技術有限公司制造生產的LTC3888DC-DC 開關控制器PMIC（電源管理集成電路）DC 到 DC 開關式控制器是用于高效率電路的穩壓 IC，其配置為生成高于（突升或步升）或低于（突降或步降）輸入電源的輸出電源電壓。其他拓?fù)浣Y(jié)構可能包括：降壓-升壓、反激、正激、Cuk、SEPIC、全橋、半橋和推挽式。這些器件不同于需要最小電壓并“燒盡”多余電壓的線性穩壓器。

DESCRIPTION

The LTC?3888/LTC3888-1/LTC3888-2 is a PMBus-compliant

dual loop DC/DC synchronous step-down switching regulator

controller with eight expandable phases supporting

a wide range of master/slave configurations. The controller

uses constant frequency current mode architecture to

provide excellent transient response and output regulation.

Each PWM master is capable of producing output voltages

from 0.3V to 3.45V with multiple phase configurations using

DrMOS devices that provide an output current monitor.

PMBus configuration and monitoring is supported by

LTpowerPlay? software. Programmable loop compensation

and built-in load step emulation facilitate setting bandwidth

based on input voltage and output load capacitance.

PMBus commands allow read back of input voltage, output

voltage and current, and operating status. Operating

parameters can be set via PMBus command or stored in

internal EEPROM for use at power up. Switching frequency,

phase configuration, output voltage (LTC3888/LTC3888-2),

output current limit (LTC3888-1) and device address can

also be set using external programming resistors.

FEATURES

- PMBus/I2C Compliant Serial Interface

- Monitor Voltage, Current, Temperature and Faults

- Digitally Program VOUT, Margins, UV, OV, Current

Limit, Soft-Start/Stop and Sequencing

- Expandable to >16 Phases

- 4.5V ≤ VIN ≤ 26.5V, 0.3V ≤ VOUT ≤ 3.45V

- ±0.5 Output Voltage Accuracy

- Programmable PWM Loop Compensation

- Accurate PolyPhase? Current Sharing

- Internal EEPROM with ECC and Fault Logging

- DrMOS Output Current Monitor Interface

- DrMOS Temperature/Fault Bus Interface

- DrMOS Gate Drive Supply Monitor

- Load Step Emulation

- Internal or External PWM Clock from 250kHz to 1MHz

- 52-Pin (5mm × 8mm) QFN Package

- AEC-Q100 Qualified for Automotive Applications

APPLICATIONS

- High Current Distributed Power Systems

- Servers, Network and Storage Equipment