TC3X9中文資料英飛凌數(shù)據(jù)手冊PDF規(guī)格書

2.1 Summary of Features

– Infineon’s TC3X9 (TC399, TC389) AURIX? 2G Controller in LFBGA-516 Package

– Infineon’s TC3X7 (TC397, TC387) AURIX? 2G Controller in LFBGA-292 Package

– Burst Flash up to 4MBytes (only with TC399)

– asynchronous SRAM up to 2MByte (only with TC399)

– synchronous SRAM up to 4MByte (only with TC399)

– FlexRay? 1) Transceivers

– High Speed CAN Transceivers (CAN-FD capable)

– USB to UART bridge

– Ethernet Gigabit PHY

– Serial Eeprom

– LIN Transceiver

– Crystal 20MHz (default) or External Clock

– USB miniWiggler JDS for easy debugging

– 8 Low Power Status LEDs

– 8-DIP switches for configuration

– access to all pins of controller

– 100mm x 160mm (EURO-Board)

Connectors

The TC3X9 TriBoard offers a wide variety of connectors:

– Standard power connector

– Micro USB connector for ASC Interface (ASC0) and miniWiggler

– RJ45 connector for Ethernet (10/100/1000)

– 16-pin header for JTAG interface (OCDS)

– 3 x 10-pin header for DAP, DAPE and DAP_SCR (DAPE only usable on Emulation Device)

– 10pin (2x5) Header for LIN Transceiver (LIN)

– 2 x 10pin (2x5) Header for CAN High Speed Transceiver (CAN0 and CAN1)

– 2 x 10pin (2x5) Header for FlexRay? (ERAY-A and ERAY-B)

– five 80-pin connectors (male) + five 80-pin connectors (female) with all I/O signals

– optional ETK connector

– optional 2 x 6pin (IEEE1394) Socket for HSCT

– optional Aurora connector (only with Emulation Device)

Components

– Infineon’s Multi Voltage Safety Micro Processor Supply TLF35584QV

– Three LEDs to validate power supply (5Volt / 3,3 Volt / 1,25 Volt)

– LED indicating safe state signal 2 from TLF35584

– LED indicating /HDRST (ESR0) active state

– LED indicating activ miniWiggler JDS

– LED switched via DAS software

– 2 x Infineon’s FlexRay? Transceiver TLE9221SX

– 2 x Infineon’s High Speed CAN-Transceiver TLE9251VSJ

Features

– Infineon’s LIN-Transceiver TLE 7259-3GE

– USB to UART bridge FT2232HL (FTDI)

– Integrated 10/100/1000M Ethernet Precision Transceiver RTL8211FI-CG (Realtek)

– 8 general purpose LEDs

– 2K I2C Serial Eeprom with EUI-48? 1) Node Identity (MICROCHIP)

– Reset switch

– Enable switch

– Generic switch

– 4-pin Dip switch

Zero Ohm Bridges

Zero Ohm resistors give the flexibility to configure the systems functionality.