THVD4431中文資料德州儀器數(shù)據(jù)手冊PDF規(guī)格書

1 Features

? Meets or exceeds the requirements of the TIA/

EIA-485A and TIA/EIA-232F standards

? 3 Transmitters, 5 receivers for RS-232

? 1 Transmitter, 1 receiver for RS-485

? On-chip switchable 120-Ω termination resistor for

RS-485 mode

? Integrated charge-pump for RS-232 signaling

? 3-V to 5.5-V supply voltage

? 1.65 V to 5.5 V Supply for logic data and control

signals

? RS-485 Differential output exceeds 2.1 V for

PROFIBUS compatibility with 5-V supply

? Large output swing (typical ± 9V) for RS-232 mode

? SLR Pin Selectable Data Rates:

– RS-232 3T5R mode: 250 kbps and 1 Mbps

– RS-485 half-duplex and full-duplex mode: 500

kbps and 20 Mbps

? Bus I/O protection

– ±16-kV HBM ESD

– ±4-kV IEC 61000-4-4 fast transient burst

? Diagnostic loopback for both RS-232 and RS-485

modes

? Shutdown pin for low current consumption (10 μA

typical) in disabled state

? Glitch-free power-up/down for hot plug-in capability

? 1/8 unit load (up to 256 bus nodes) for RS-485

? Open, short, and idle bus failsafe for RS-485

receiver

? Bus short-circuit protection, thermal shutdown

? Extended ambient temperature range: -40°C to

125°C

? Space-saving thermally efficient 6 mm x 6 mm

VQFN-40 package

2 Applications

? Industrial PC

? Factory automation and control

? HVAC systems

? Building automation

? Point-of-sale terminals

? Grid infrastructure

? Industrial Transport

3 Description

THVD4431 is a highly integrated and robust

Multiprotocol transceiver supporting RS-232, RS-422

and RS-485 physical layers. The device has three

transmitters and five receivers to enable 3T5R

RS-232 port. The device also integrates one

transmitter and one receiver to enable half and full

duplex RS-485 port. MODE selection pins enable

shared bus and logic pins for the protocols to share

a common single connector. Integrated termination for

RS-485 bus pins and for RS-232 receiver inputs need

no external components to realize a fully-functional

communication port. The device has a slew rate

select feature that enables it for use at two maximum

speeds based on the SLR pin setting.

The device features integrated Level 4 IEC ESD

protection, eliminating the need for external systemlevel

protection components. Diagnostic loopback

mode for both RS-232 and RS-485 is provided to

check for logic to bus and bus to logic path functional

integrity and check for cable and connector shorts. In

addition, the RS-485 receiver fail-safe feature drives

logic high on received logic output when the bus

inputs are open or shorted together or when the bus

is idle. Shutdown mode consumes ultra-low current

(10 μA typical) ideal for power-sensitive applications.

The device needs 3 to 5.5 V supply that powers the

charge pump for RS-232 and the drivers/receivers for

both RS-232 and RS-485. A separate logic supply

VIO (1.65 V to 5.5 V) enables interface with low level

microcontrollers.